VEHICLE WRAP BLOG

How to Care for Fleet Wraps: Washing, Damage and End-of-Life

GET A QUOTE CALL US

How to Care for Fleet Wraps: Washing, Damage and End-of-Life

Fleet wrap care comes down to a few habits: wash by hand where you can, wipe fuel, bird droppings, sap and tar off as soon as you see them, skip brush washes and the wax add-ons at the car wash, keep pressure washers well back from the edges, and check for lifted edges after every wash. Hand washing is the safer choice, because film manufacturers don’t agree on automatic washes.

How long a wrap keeps looking good depends on the film, the surface it’s on, how much sun it sees and how it’s cared for. Care is the part your crews control, so a wrapped fleet does better with a written routine than with washes whenever someone gets to it.

The guidance below draws on two film manufacturers’ care documents: a 2024 instructional bulletin and a 2015 care sheet. Each covers its maker’s own films, so ask your installer which film is on your vehicles and follow that maker’s instructions.

A simple fleet wrap care routine

Both documents describe a similar hand wash:

  1. Pre-rinse with clean water to float off grit.
  2. Wash with water and a mild car wash soap, using a soft sponge or microfiber mitt, from the top down.
  3. Rinse thoroughly with clean water.
  4. Let it air dry, or dry it with a microfiber towel.

The 2024 bulletin says a wrap should ideally be cleaned every two weeks, and whenever it looks dirty. The 2015 care sheet doesn’t give a frequency. On a fleet, put washes on the same calendar as other routine maintenance.

Automatic washes are where the two documents split. The 2024 bulletin accepts a brushless, spray-only automatic wash but not brush washes, which can scratch the film and catch and lift its edges. The 2015 care sheet advises against automated car washes altogether. If your crews use a drive-through wash, check your film’s guidance first. Either way, skip the wax options at the wash: the 2024 bulletin warns that waxes containing petroleum distillates can damage a wrap.

What to wipe off right away

The 2024 bulletin says bugs, bird droppings, tree sap and tar should be spot-cleaned immediately because they can stain and damage the film, and that the same is true of gasoline and other fuels. The 2015 care sheet says to clean all fuel spills as soon as possible.

For work trucks, the fuel pump is the moment to watch. A clean, soft, non-abrasive cloth in the cab lets drivers wipe drips around the fuel door before they pull away.

Green tanker truck with printed graphics on the cab and tank, parked on a driveway

Cleaners and waxes to avoid

The 2024 bulletin says cleaning products should have a pH between 5 and 9 and be free of abrasives, and it rules out aromatic solvents such as acetone, MEK, toluene, paint thinner and lacquer thinner. It also says to test any new product on an inconspicuous spot first.

Wax needs the same caution. The 2015 care sheet says no carnauba-based wax over vinyl graphics, and the 2024 bulletin allows a spray wax only if it has no petroleum distillates or abrasives.

Can you pressure wash a vehicle wrap?

Only as a last resort. Both documents say to pressure wash only when other cleaning methods haven’t worked or aren’t available, and both warn it can lift edges and wear down the face of the film. The 2015 care sheet also lists pressure washers among the things not to use, then gives limits for when there’s no other option. The limits differ, so don’t average them:

DocumentWater pressureDistanceNozzle and angleWater temperature
2024 manufacturer bulletinBelow 1,200 psiAt least 12 in. from the edgesNozzle perpendicular to the graphic, 40° wide spray patternBelow 180°F
2015 manufacturer care sheet, vertical panels800 psi or less15 in. from the graphic40° wide pattern at a 45° spray angle, about 30 seconds; no turbo nozzle67°F to 77°F

Even the spray direction differs: perpendicular to the graphic in one, a slight angle to the edge in the other. Ask your installer which film you have before anyone picks up a pressure wand.

Matte and textured fleet finishes need gentler care

The 2015 care sheet says not to apply any wax or polish to matte or carbon fiber finished vinyls, and the 2024 bulletin notes that matte and satin films may show fingerprints and lists separate cleaners for them. Wash matte panels the same gentle way, skip anything sold for shine, and test spot cleaners on a hidden area first. Our matte charcoal F-150 wrap for The Running PTS, with orange and black geometric graphics, is a good example of a work truck that needs this kind of care.

Side view of The Running PTS wrap graphics on a charcoal Ford F-150 door

Where and how you park matters

Dirt, UV light and heat wear film down over time, and hoods and roofs take the most sun. The 2024 bulletin says to park in shade, a garage or under cover whenever possible. On a fleet lot, give the covered spots to the vehicles with the most wrapped surface.

Check edges after every wash and catch damage early

Lifting edges and seams, trapped dirt and close pressure washing are common failure points. A quick walk-around after each wash catches problems while they’re small: look along panel edges, seams, door gaps, wheel arches and the rear doors or tailgate.

If an edge has lifted, don’t pick at it or hit it with a pressure washer. Note the vehicle and panel and have your installer look at it. The 2024 bulletin advises contacting the installer for an assessment as soon as you notice loss of gloss, discoloration or other decline in the film.

Keep the approved print files for every vehicle type, too. If a panel is damaged, the original files make a matching replacement far easier.

On the rear safety panel on a Liberty Waste Solutions truck, the “NO CAN LEFT BEHIND” message and the caution panel with wide-turn and backing warnings only do their job while they stay clean and legible.

Rear of a red garbage truck with a NO CAN LEFT BEHIND message and a yellow caution panel

When fleet graphics need to come off

Graphics come off for ordinary reasons: a rebrand, a new web address, selling a vehicle or returning a leased one, so plan for it as part of each vehicle’s life.

Removal is a job for a professional: the film is warmed and pulled slowly, then leftover adhesive is cleaned off. The paint underneath and the film’s age affect how it goes. As we explain in our post on how color PPF and vinyl compare, “Both are designed to be removable from sound factory paint. The risk goes up with resprayed panels, paint that was already damaged, and film left on well past its rated life.”

So note any repainted panels when a vehicle is first wrapped, and don’t leave faded graphics on well past their useful life. A printed wrap also isn’t paint protection film and isn’t designed to stop rock chips.

Fleet wrap care FAQ

Is a touchless car wash OK for a wrapped van?

It depends on the film. One manufacturer accepts a brushless, spray-only wash; the other advises against automated washes. Hand washing is the safer choice, and both rule out brush washes.

Can we pressure wash our wrapped trucks?

Only as a last resort, and only within your film maker’s limits, which differ as the table above shows.

Can we wax a vehicle wrap?

Only a wax your film maker allows, and under the 2015 care sheet, none on matte. The 2024 bulletin accepts a spray wax free of petroleum distillates and abrasives; the 2015 care sheet rules out carnauba-based wax.

What should we do about a lifted edge?

Leave it alone and have your installer look at it. Don’t pick at it or pressure-wash it in the meantime.

Keep your fleet looking sharp

If you have care questions, or a vehicle with a lifted edge or graphics that need updating, get your fleet graphics checked by talking to our Raleigh team, and ask which care guidance fits the film on your vehicles. The same habits apply to a single work van with business vehicle wraps.

START YOUR
NEXT PROJECT

Make sure your business stands out in Raleigh, North Carolina by choosing our team at King Tutt Graphics for help with vehicle wraps, banners, and more.

Stand Out On The Road

Impactful Branding For Your Business

GET STARTED